When a vessel is entering or leaving a port, a record of engine speeds is kept in the __________.?
A) bell book B) deck rough log C) Official Logbook D) engine rough log E)NULL
Soru Kategorisi Güverte
What is the volume in a cone with a base diameter of 8 feet and a height of 6 feet?
A) 100.53 ft B) 131.39 ft C) 172.72 ft D) 197.39 ft E)NULL
The half-breadth plan is __________.?
A) an endwise view of the ship’s molded form B) a plan with the forebody to right of centerline and afterbody to the left of centerline C) a longitudinal side elevation D) usually drawn for the port side only E)NULL
The shearing stresses on a ship’s structure are usually greatest at __________.?
A) the bow B) the stern C) midships D) the ship’s quarter-length points E)NULL
The vessel’s “quarter” is located __________.?
A) abeam B) dead astern C) just forward of the beam on either side D) on either side of the stern E)NULL
Which would you NOT use to report the amount of anchor chain out? “Three shots __________.”?
A) at the water’s edge B) on deck C) on the bottom D) well in the water E)NULL
A mooring line leading 45° to the keel, used to check forward or astern movement of a vessel, is called a __________.?
A) spring line B) warp line C) bow line D) breast line E)NULL
A vessel loads 5000 tons of manganese ore. The railroad cars that brought the ore to the vessel were previously loaded with iron ore so the ore is contaminated. The agent requests the Master to sign a Clean Bill of Lading and in return the shipper will give him a Letter of Indemnity. What is the best procedure to follow?
A) Sign a Clean Bill of Lading and accept the Letter of Indemnity. B) Refuse to sign a Clean Bill of Lading. C) Sign the Clean Bill of Lading and have the agent countersign it. D) Sign a Clean Bill…
What is the area of a circle with a diameter of 12 feet after a sector of 86° has been removed?
A) 108.57 square ft. B) 86.08 square ft. C) 28.65 square ft. D) 27.14 square ft. E)NULL
You are conducting trials to determine the maneuvering characteristics of your vessel. While making a turn, you take ranges and bearings of an isolated light with the results shown in illustration D034DG. Based on this information, what is the transfer for a turn of 180°?
A) 875 yards B) 910 yards C) 975 yards D) 1015 yards E)NULL